The 14 sizes of regular roller chains are available ranging from 25 to 240 like those in conformity with ANSI (Mixture CHAIN American National Regular Institute), and ISO (Worldwide Organization for Standardization).
The chains not just meet the prerequisites for the minimal tensile power prescribed by ANSI and ISO, but they also offer the major class good quality from the planet which include a substantial fatigue power
Appropriate makes use of
?General use for driving 
and lifting gear.
Examples
?Driving transfer units along with other tools. For multilevel parking.
Variety of chains
For variety of a chain, see the tables of “Max. Horsepower Ratings” for common roller chains and “Designing of Chain Transmission”. However, only to get a unique situation of lower velocity and less shock, “Low-speed selection” strategy also can be referred to.
Conventional roller chains up to 5 strands can be found. The common technique for connecting pins and plates is rivet style (RP).
The cotter kind (CP) is available for typical chains and HK chains of 80 or bigger.
Sprockets
The typical roller chains might be engaged with common sprockets of the corresponding nominal numbers. For sprockets, refer for the table of “Dimensions” for every dimension of chain.
Connecting links and offset back links
For connecting hyperlinks and offset back links, refer towards the table of “Dimensions” for each size of chain.
The connecting hyperlinks are normally R or C connecting back links by which the pins are clearance-fitted with the connecting plate. Because clearance-fitted backlinks are inferior on the base chain in Max. allowable tension as within the situation of one-pitch offset links (OJ), “Low-speed selection” cannot be referred to. Because the Max. kilowatt ratings are determined looking at the strength of connecting links and OJ, the clearance-fitted connecting links and OJ can be utilised if your chains are picked according on the “General selection”. Whenever a higher Max. allowable tension is required for that connecting hyperlink, utilize the interference-fitted connecting hyperlink (H connecting link) of the HI-PWR-S chain, and during the case of offset back links, use 2POJ.
