Electrical power UNITS FOR LIFT TABLE one
General Description
This energy unit is created exclusively for your small lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit has become widely utilized inside the business of logistic units which include minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is controlled by the solenoid valve with all the speed controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Common Description
This power unit is built exclusively for that medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve and the speed managed by the adjustable needle valve. When the lift rises to a higher positoin, however the energy provide is reduce, the decreasing motion is managed through the manual override function.
Electrical power UNITS FOR LIFT TABLE three
Standard Description
This power unit is developed solely for that huge lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve as well as the pace managed by a stress compensated movement control valve.
Power UNITS FOR LIFT TABLE 4
General Description
This power unit is developed solely to the substantial 
lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve as well as pace managed through the adjustable needle valve. Once the lift rises to a large positoin, but the electrical power provide is reduce, the decreasing movement is controlled through the guide override function.
Exclusive Notes
1. This energy unit is of S3 duty cycle, which can only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean every one of the hydraulic elements concerned in advance of set up of the power unit.
three. Viscosity of your oil shoud be 15~46 cst,which should also be clean and no cost of impurities.N46 hydraulic oil is suggested.
four. Oil transforming is needed just after the initial one hundred operation hrs,afterwards once every 3000 hrs.
five. The power unit shown is designed to be mounted vertically.
